Mesh Safety Cover: Use and Care Information
The water level in the pool should always be kept within 12" of the top of the pool wall.
Initially, adjust the straps so that they are set to at least half compression. This will keep the cover tight and aid in draining. The springs should be checked periodically and the straps adjusted to maintain this tension.
Be sure your pool has the proper level of sanitizer and algaecide before closing it for the winter. This will insure that the water is clear upon opening in the spring. If the cover is left on when the temperature has gone beyond 60 degrees F., it may be necessary to add algaecide to maintain clarity.
Snow & Water
Large accumulations of snow should be carefully removed, taking precautions not to damage the cover. Likewise, if a large puddle of water accumulates, it should be removed immediately by directing it to the drain or by using a weighted cover pump. The straps should be readjusted to prevent a reoccurrence. Failure to perform this maintenance could result in stretching or damage to the other cover components. Drainage can be facilitated by slightly loosening the strap that runs through the drain areas while tightening the straps away from the drain. A small amount of puddling is normal and will evaporate in dry weather. If you have questions about these or any procedures, please contact your cover installer.
Debris & Standing Water
Standing water resulting from melting snow and rain must be removed immediately. Covered pools located in heavily wooded areas are susceptible to accumulation of leaves, needles and other debris that will inhibit water flow to and through the "Invis-A-Drain". It is very important to keep the drain clear of debris at all times. Water can be removed by placing a weighted pool cover pump in a suitable location on the cover. Cover pumps are available local pool dealers.
For covers not ordered with sewn-on padding, it is required that our loose 2'x 20' padding be placed as a barrier between rough or sharp coping and the cover itself. Failure to do so will void the warranty. Periodic examination of the cover is necessary for detection of early signs of wear.
The cover may be hosed off and should be allowed to dry before fan folding for storage in its mesh bag. Cover cleaner and treatments, available at most pool supply stores, are also recommended.
After removing or prior to installing the cover, clean out all the anchor sockets with a stream of compressed air or water. This biannual cleaning will assure proper anchor function. Applying spray silicone to these components will also be beneficial to their proper operation. When the cover is not in use, screw anchors down completely to keep out debris and prevent tripping and foot injuries.